pentair screenlogic interface wireless link lights

'Note: The above ScreenLogic Interface Kits (520502) require a four-wire, 22-gauge wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter within the home. I was just hoping part of the kit I already had installed given my system already has the wireless pentair controller. My question was really around the wireless connection which they have an entire kit for (p/n 521964). I would also contact the manufacturer of your existing pool controller to see if third party integration is even a possibility with your current model to make sure your not on a wild goose chase This will then allow for a easy integration and also provide an app for further control. My best advise is to install a verifiable pool controller that has a ip driver available. Still searching for some advice in this scenario.

My sense is that others must have installed in some situations without a direct cable connection. There are several parts to buy or that you could buy so wanted to make sure i get it right. Pentair sells an entire Wireless Package for its Screenlogic system but the wireless receiver looks identical to the one i already have installed. The other scenario that is less clear is using the existing Pentair wifi used for EZtouch remote to broadcast to a Pentair transceiver, then the transceiver integrates into the home network (or maybe even rs232). I think i have it understood for the scenario running a wire to the control unit. I don't recall ever seeing a pentair EZ touch driver so that could also be a limiting factor. It also has to be a unit that allows for integration. Every pool that I've integrated needed a wire to the controller to either provide a network connection or to use rs232.

Pentair screenlogic interface wireless link lights